Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 97

Probable
Indicates that too many interrupts in the embedded port caused the specified chip to be disabled. The
Cause
probable cause is too many abnormal frames; the chip is disabled to prevent the CP from becoming too
busy.
Recommended Make sure to capture the console output during this process.
Action
Check for a faulty cable, SFP, or device attached to the specified port.
Run the systemVerification command to verify that the blade or switch does not have hardware
problems.
On a bladed switch, run the slotPowerOff and slotPowerOn commands.
On a nonbladed switch, reboot or power cycle the switch.
If the message persists, replace the blade or the nonbladed switch.
Severity CRITICAL
BL-1012
Message
<timestamp>, [BL-1012], <sequence-number>,, ERROR, <system-name>,
bport <port number> port int. is disabled. status=0x<interrupt
status> Port <port number> will be re-enabled in 1 minute.
Probable
Indicates that the port generated an excessive number of interrupts that might prove fatal to the switch
Cause operation. The port is disabled to prevent the CP from becoming too busy. The bport is the blade port;
this number might not correspond to a user port number.
Recommended Make sure to capture the console output during this process.
Action
Check for a faulty cable, SFP, or device attached to the specified port.
On a bladed switch, run the slotPowerOff and slotPowerOn commands.
On a nonbladed switch, reboot or power cycle the switch.
If the message persists, replace the blade or the nonbladed switch.
Severity ERROR
BL-1013
Message
<timestamp>, [BL-1013], <sequence-number>,, ERROR, <system-name>,
bport <port number> port is faulted. status=0x<interrupt status>
Port <port number> will be re-enabled in 1 minute.
Probable
Indicates that the port generated an excessive number of interrupts that might prove fatal to the switch
Cause operation. The port is disabled to prevent the CP from becoming too busy. The bport is the blade port;
this number might not correspond to a user port number.
Fabric OS Message Reference
Publication Number: 53-1000242-01
3
BL-1012
3-5