Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 80

2
AUTH-1004
Probable
Indicates an authentication configuration value was set to the specified value. The data type is either
Cause
"authentication type" or "DH group type".
Recommended
No action is required.
Action
Severity
INFO
AUTH-1004
Message
<timestamp>, [AUTH-1004], <sequence-number>,, ERROR, <system-name>,
Failed to set <data type> type to <setting value>.
Probable
Indicates that the authUtil command has failed to set the authentication configuration value. The data
Cause type is either "authentication type" or "DH group type".
Recommended
Retry the authUtil command.
Action
Run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command
and contact your switch service provider.
Severity ERROR
AUTH-1005
Message
<timestamp>, [AUTH-1005], <sequence-number>,, ERROR, <system-name>,
Authentication file does not exist: <error code>.
Probable Indicates an authentication file corruption.
Cause
Recommended
Run the firmwareDownload command to reinstall the firmware.
Action
Run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command
and contact your switch service provider.
Severity
ERROR
AUTH-1006
Message
<timestamp>, [AUTH-1006], <sequence-number>,, WARNING, <system-
name>, Failed to open authentication configuration file.
2-2 Fabric OS Message Reference
Publication Number: 53-1000242-01