Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 472

63
SYSC-1003
SYSC-1003
Message
<timestamp>, [SYSC-1003], <sequence-number>, FFDC, CRITICAL,
<system-name>, Chassis config option <Option number read from the
chassis option storage device> is not supported by CP Blade with ID
<Blade ID (platform) number from the Active CP>. Change the chassis
configuration <Steps to change chassis configuration>
Probable Indicates that on system startup, the option configuration file corresponding to the chassisConfig option
Cause
read could not be found. This indicates that option is not supported on this platform running this version
of the firmware.
It could also indicate that the current option number could not be read from the chassis option storage
device (the WWN card).
This message occurs only on the SilkWorm 24000 and 48000.
Recommended Run the chassisConfig command to change to one that is valid on this platform running this firmware.
Action
Note that the chassisConfig option 1 should be valid for all platforms running any valid firmware.
Severity CRITICAL
SYSC-1004
Message
<timestamp>, [SYSC-1004], <sequence-number>,, INFO, <system-name>,
Daemon <Daemon name to restart> restart successful
Probable
Indicates that a terminated daemon is restarted by system automatically.
Cause
Recommended
Use the supportSave command to gather troubleshoot data. No further action is required.
Action
Severity
INFO
SYSC-1005
Message
<timestamp>, [SYSC-1005], <sequence-number>,, WARNING, <system-
name>, Daemon <Daemon name to restart> is not restarted (Reason:
<Restart failure reason>)
Probable Indicates that a terminated daemon is not restarted, either due to restart limit is reached or restart action
Cause
fails
63-2 Fabric OS Message Reference
Publication Number: 53-1000242-01