Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 508

73
ZONE-1018
ZONE-1018
Message
<timestamp>, [ZONE-1018], <sequence-number>,, ERROR, <system-name>,
Incorrect zoning enforcement type(<zone type>) at port(<port
number>)
Probable
Indicates that an incorrect zoning enforcement type was reported on the specified port. This is a
Cause
software error. A QuickLoop zone type (value = 4) or an uninitialized type (value = 0) are invalid. The
valid zone type values are:
•
hard port zone (value = 1)
•
hard wwn zone (value = 2)
•
session based hard zoning (value = 3)
•
FA zone (value = 5)
QuickLoop zones are not supported in Fabric OS v4.x.
Recommended
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
Action supportSave command and contact your switch service provider.
Severity
ERROR
ZONE-1019
Message
<timestamp>, [ZONE-1019], <sequence-number>,, ERROR, <system-name>,
Transaction Commit failed. Reason code <reason code> (<Application
reason>) - \"<reason string>\"
Probable Indicates that the Reliable Commit Service (RCS) had a transmit error. RCS is a protocol used to
Cause
transmit changes to the configuration database within a fabric.
Recommended Often this message indicates a transitory problem. Wait a few minutes and retry the command.
Action
Make sure that your changes to the zone database are not overwriting the work of another admin.
Run the cfgTransShow command to find out if there is any outstanding transaction running on the local
switches.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
ERROR
73-6 Fabric OS Message Reference
Publication Number: 53-1000242-01