Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 89

AUTH-1033
Message
<timestamp>, [AUTH-1033], <sequence-number>,, ERROR, <system-name>,
Disable port <port number> due to unauthorized switch <switch WWN
value>
Probable
Indicates that an entity was not configured in the SCC policy and tried to connect to the port.
Cause
Recommended
Add the entity's WWN to the SCC policy and reinitialize authentication by using the portDisable and
Action portEnable commands or the switchDisable and switchEnable commands.
Severity
ERROR
AUTH-1034
Message
<timestamp>, [AUTH-1034], <sequence-number>,, ERROR, <system-name>,
Failed to validate name <entity name> in <authentication message>:
port <port number>
Probable Indicates that the specified entity name in the payload is not in the correct format.
Cause
Recommended Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
Action
switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
ERROR
AUTH-1035
Message
<timestamp>, [AUTH-1035], <sequence-number>,, ERROR, <system-name>,
Invalid <data type> length in <message phase> message: length <data
length>, port <port number>
Probable Indicates that a particular data field in the authentication message has an invalid length field. This error
Cause
usually relates to internal failure.
Recommended Usually this problem is transient. The authentication might fail.
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
Fabric OS Message Reference
Publication Number: 53-1000242-01
2
AUTH-1033
2-11