Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 467

SWCH System Messages
SWCH-1001
Message
<timestamp>, [SWCH-1001], <sequence-number>,, ERROR, <system-name>,
Switch is not in ready state - Switch enable failed switch status=
0x<switch status>, c_flags = 0x<switch control flags>
Probable
Indicates that the switch is enabled before it is ready.
Cause
Recommended If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
Action supportSave command and contact your switch service provider.
Severity ERROR
SWCH-1002
Message
<timestamp>, [SWCH-1002], <sequence-number>,, INFO, <system-name>,
Security violation: Unauthorized device <wwn name of device> tries
to flogin to port <port number>
Probable
Indicates that the device is not present in the authorized profile list.
Cause
Recommended
Verify that the device is authorized to log in to the switch. If the device is authorized, run the
Action secPolicyDump command to verify whether the specified device WWN is listed. If it is not listed, run
the secPolicyAdd command to add this device to an existing policy.
Severity INFO
Fabric OS Message Reference
Publication Number: 53-1000242-01
Chapter
62
62-1