Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 144

11
FABR-1008
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
WARNING
FABR-1008
Message
<timestamp>, [FABR-1008], <sequence-number>,, WARNING, <system-
name>, <error description>
Probable
Indicates that errors occurred during the request domain ID state; the information unit cannot be
Cause allocated or sent. If this message occurs with FABR-1005, the problem is usually transitory. Otherwise,
this message is rare and usually indicates a problem with the Fabric OS. The error descriptions are as
follows:
•
FAB RDI: cannot allocate IU
•
FAB RDI: cannot send IU
Recommended No action is required if the message appears with the FABR_1005 message.
Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING
FABR-1009
Message
<timestamp>, [FABR-1009], <sequence-number>,, WARNING, <system-
name>, <error description>
Probable
Indicates that errors were reported during the exchange fabric parameter state; cannot allocate domain
Cause
list due to a faulty EFP type. This message is rare and usually indicates a problem with the Fabric OS.
Recommended
The fabric daemon will discard the EFP. The system will recover through the EFP retrial process.
Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
WARNING
FABR-1010
Message
<timestamp>, [FABR-1010], <sequence-number>,, WARNING, <system-
name>, <error description>
11-4 Fabric OS Message Reference
Publication Number: 53-1000242-01