Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 401

Probable
Indicates that the security database size is not supported by the standby CP.
Cause
Recommended
Reduce the security database size by reducing the number of entries within each policy.
Action
Severity
WARNING
SEC-1032
Message
<timestamp>, [SEC-1032], <sequence-number>,, ERROR, <system-name>,
Empty FCS list is not allowed.
Probable
Indicates that there has been a corruption during the distribution of the security database. This can only
Cause occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurrence.
Recommended Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
Action
in the ready state. If a switch is in the error state, the database might not be correctly updated for that
specific switch.
Severity
ERROR
SEC-1033
Message
<timestamp>, [SEC-1033], <sequence-number>,, ERROR, <system-name>,
Invalid character used in member parameter to add switch to SCC
policy; command terminated.
Probable Indicates that the member parameter in the secPolicyAdd command is invalid (such as the asterisk
Cause
symbol). Only valid switch identifiers, that is WWN, domain ID or switch name are supported for the
member parameter. The asterisk symbol can be used to add all switches only with the secPolicyCreate
command.
Recommended Run the secPolicyAdd command using a valid switch identifier (WWN, domain ID, or switch name) to
Action
add specific switches to the SCC policy.
Refer to the Fabric OS Command Reference for more information on the secPolicyAdd and
secPolicyCreate commands.
Severity
ERROR
Fabric OS Message Reference
Publication Number: 53-1000242-01
58
SEC-1032
58-7