Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 415

SEC-1083
Message
<timestamp>, [SEC-1083], <sequence-number>,, ERROR, <system-name>,
Name already exists.
Probable Indicates that there has been a corruption during the distribution of the security database. This can only
Cause
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurrence.
Recommended
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
Action in the ready state. If a switch is in the error state, the database might not be correctly updated for that
specific switch.
Severity ERROR
SEC-1084
Message
<timestamp>, [SEC-1084], <sequence-number>,, ERROR, <system-name>,
Name exists for different type <Policy name>.
Probable
Indicates that the specified policy already exists.
Cause
Recommended
No action is required.
Action
Severity
ERROR
SEC-1085
Message
<timestamp>, [SEC-1085], <sequence-number>,, ERROR, <system-name>,
Failed to create <policy name>.
Probable
Indicates that the security policy was not created.
Cause
Recommended Check that the current policy configuration is valid. For example, the RSNMP policy cannot exist
Action without the WSNMP policy.
Severity ERROR
Fabric OS Message Reference
Publication Number: 53-1000242-01
58
SEC-1083
58-21