Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 408

58
SEC-1055
Recommended
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
Action
in the ready state. If a switch is in the error state, the database might not be correctly updated for that
specific switch.
Severity ERROR
SEC-1055
Message
<timestamp>, [SEC-1055], <sequence-number>,, ERROR, <system-name>,
Invalid FCS list <WWN list>
Probable Indicates that there has been a corruption during the distribution of the security database. This can only
Cause
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurrence.
Recommended
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
Action in the ready state. If a switch is in the error state, the database might not be correctly updated for that
specific switch.
Severity ERROR
SEC-1056
Message
<timestamp>, [SEC-1056], <sequence-number>,, ERROR, <system-name>,
Invalid position <New position>. Only <Number of members in FCS
list> members in list.
Probable
Indicates that there has been a corruption during the distribution of the security database. This can only
Cause occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurrence.
Recommended Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
Action
in the ready state. If a switch is in the error state, the database might not be correctly updated for that
specific switch.
Severity
ERROR
SEC-1057
Message
<timestamp>, [SEC-1057], <sequence-number>,, ERROR, <system-name>,
No change. Both positions are the same.
58-14 Fabric OS Message Reference
Publication Number: 53-1000242-01