Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 431

SEC-1153
Message
<timestamp>, [SEC-1153], <sequence-number>,, INFO, <system-name>,
Error in RCA: RCS is not supported
Probable Indicates that RCS is not supported.
Cause
Recommended Run the rcsInfoShow command to view RCS capability on the fabric. RCS must be capable on all
Action
switches in the fabric to be enabled. If all switches are capable, it is automatically enabled.
For any switch that does not support RCS, obtain the latest firmware version from your switch supplier,
and run the firmwareDownload command to upgrade the firmware.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity INFO
SEC-1154
Message
<timestamp>, [SEC-1154], <sequence-number>,, INFO, <system-name>,
PID change failed: <Reason> <defined status> <active status>.
Probable Indicates that either the defined or the active policy could not be updated. If the policy database is very
Cause
large, it might not be able to change the index/area because the new policy database exceeds the
maximum size. This message can also be caused when the switch is short of memory. The status values
can be either defined, active, or both. A negative value means that a policy set was failed by the
daemon.
Recommended
Reduce the size of the policy database.
Action
Severity
INFO
SEC-1155
Message
<timestamp>, [SEC-1155], <sequence-number>,, INFO, <system-name>,
PID change failed: <Reason> <defined status> <active status>.
Probable
Indicates that either the defined or active policy was too large after modifying the index/area ID. The
Cause status values can be either defined, active, or both. A negative value means that a policy set was failed
by the daemon.
Fabric OS Message Reference
Publication Number: 53-1000242-01
58
SEC-1153
58-37