Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 553

SULB-1021
Message
AUDIT, <timestamp>, [SULB-1021], WARNING, FIRMWARE, <event-
initiator-details>, <event-location>, , Firmware is being
downloaded to the blade in slot <Slot number>.
Probable
Indicates that the firmware is being loaded to the indicated blade.
Cause
Recommended
Run the firmwareDownloadStatus command to monitor the firmwareDownload progress. After it
Action finishes, run the firmwareShow command to verify the firmware versions.
Severity WARNING
SULB-1023
Message
AUDIT, <timestamp>, [SULB-1023], WARNING, FIRMWARE, <event-
initiator-details>, <event-location>, , The blade in slot <Slot
number> has rebooted during firmwaredownload.
Probable
The error can be caused by an unexpected disruption of the firmwareDownload command, for
Cause example, powering off and on of the indicated BP blade in the middle of a firmwareDownload. This
error can also be caused by persistent storage hardware failure, or a software error.
Recommended firmwareCommit will be started automatically after the blade boots up. If at the end of
Action
firmwareCommit, the blade firmware version is still inconsistent with the active CP firmware,
firmwaredownload will be started automatically to the blade again. Continue to run the
firmwareDownloadStatus command to monitor the progress. However, if this problem persists,
contact the service provider for further actions.
Severity
WARNING
SULB-1024
Message
AUDIT, <timestamp>, [SULB-1024], WARNING, FIRMWARE, <event-
initiator-details>, <event-location>, , Firmware commit has
completed on the blade in slot <Slot number>.
Probable Indicates that the firmwareCommit operation has completed on the indicated blade.
Cause
Fabric OS Message Reference
Publication Number: 53-1000242-01
79
SULB-1021
79-11