Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 192

19
FICU-1003
FICU-1003
Message
<timestamp>, [FICU-1003], <sequence-number>,, WARNING, <system-
name>, <function name>: <message> FICON-CUP License Not Installed
(<error>)
Probable
Indicates that the FICON-CUP license is not installed on the switch.
Cause
Recommended
Run the licenseShow command to check the installed licenses on the switch. The switch cannot be
Action managed using FICON-CUP commands until the FICON-CUP license is installed. Contact your switch
supplier for a FICON-CUP license. Run the licenseAdd command to add the license to your switch.
Severity WARNING
FICU-1004
Message
<timestamp>, [FICU-1004], <sequence-number>,, WARNING, <system-
name>, <function name>: Failed to set FMS mode: conflicting PID
Format:<pid_format>, FMS Mode:<mode>
Probable
Indicates that a PID format conflict was encountered. The core PID format is required for FICON-CUP.
Cause
The pid_format variable displays the PID format currently running on the fabric, and is one of the
following:
•
0 is VC-encoded PID format
•
1 is core PID format
•
2 is extended-edge PID format
FMS mode displays whether FICON Management Server mode is enabled; a 0 means this mode is
enabled and a 1 means this mode is disabled.
Recommended
For FICON Management Server mode (fmsMode) to be enabled, the core PID format must be used in
Action
the fabric. Change the PID format to core PID using the configure command and reenable fmsmode
using the ficoCupSset command. Refer to the Fabric OS Administrator's Guide for information on core
PID mode and the Fabric OS Command Reference for information on the configure command and
ficonCupSet command.
Severity
WARNING
19-2 Fabric OS Message Reference
Publication Number: 53-1000242-01