Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 81

Probable
Indicates an internal problem with the Secure Fabric OS.
Cause
Recommended
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
Action switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING
AUTH-1007
Message
<timestamp>, [AUTH-1007], <sequence-number>,, ERROR, <system-name>,
The proposed authentication protocol(s) are not supported: port
<port number>.
Probable
Indicates that the proposed authentication protocol type or types are not supported by the local specified
Cause port.
Recommended Run the authUtil command to make sure the local switch supports the specified protocols: FCAP or
Action DH-CHAP.
Severity ERROR
AUTH-1008
Message
<timestamp>, [AUTH-1008], <sequence-number>,, ERROR, <system-name>,
No security license, operation failed.
Probable Indicates that the switch does not have a security license.
Cause
Recommended Verify that the security license is installed using the licenseShow command. If necessary, reinstall the
Action
license using the licenseAdd command.
Severity
ERROR
AUTH-1010
Message
<timestamp>, [AUTH-1010], <sequence-number>,, ERROR, <system-name>,
Failed to initialize security policy: switch <switch number>, error
<error code>.
Fabric OS Message Reference
Publication Number: 53-1000242-01
2
AUTH-1007
2-3