Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 184

18
FCR-1054
FCR-1054
Message
<timestamp>, [FCR-1054], <sequence-number>,, WARNING, <system-
name>, Port <port number> received ILS <command> of incorrect size
(<actual payload size>); valid ILS size is <expected payload size>.
Probable
Indicates that an internal link service (ILS) IU of invalid size was received from the switch on the other
Cause
end of the link.
Recommended
Check the error message log on the other switch using the errShow command for additional messages.
Action
Check for a faulty cable or deteriorated SFP. Replace the cable or SFP if necessary.
Run the portLogDumpPort command on both the receiving and transmitting port.
Run the fabStateShow command on transmitting switch.
If the message persists, collect switch information using the supportShow command, and contact your
switch service provider.
Severity WARNING
FCR-1055
Message
<timestamp>, [FCR-1055], <sequence-number>,, INFO, <system-name>,
Switch with domain ID <domain ID> does not support backbone to edge
imports.
Probable
Indicates that a switch that does not support backbone to edge routing was detected in the backbone.
Cause Edge to edge routing will work, but backbone to edge routing might fail.
Recommended
No action is required if backbone to edge routing is not required. Otherwise replace the switch with one
Action that supports backbone to edge routing.
Severity INFO
FCR-1056
Message
<timestamp>, [FCR-1056], <sequence-number>,, INFO, <system-name>,
Switch <switch WWN> with front domain ID <domain ID> does not
support backbone to edge imports.
Probable Indicates that a switch that does not support backbone to edge routing is running in the MetaSAN.
Cause
18-16 Fabric OS Message Reference
Publication Number: 53-1000242-01