Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 130

9
EM-1035
Run the systemVerification command to verify that the switch does not have hardware problems. Refer
to the Fabric OS Command Reference for more information on this command.
If the message persists, replace the FRU.
Severity
ERROR
EM-1035
Message
<timestamp>, [EM-1035], <sequence-number>,, ERROR, <system-name>, 2
circuit paired Power Supplies are faulty, please check the <Switch
side> AC main switch/circuit to see if it has power.
Probable
Suggests that since both Power Supplies associated with one of the 2 main circuits are present but
Cause
faulty, maybe the circuit's switch has been turned off, or the AC power source has been interrupted for
that circuit.
The Switch side value is either "left" or "right" designating which circuit switch, facing the cable side of
the chassis. The Switch side value indicates:
•
"left": controls the odd numbered power supply units.
•
"right": controls the even numbered power supply units.
Recommended
Check that the identified AC circuit switch is turned on, that the power cord is properly attached and
Action
undamaged, and that the power source is operating properly.
Severity
ERROR
EM-1036
Message
<timestamp>, [EM-1036], <sequence-number>,, WARNING, <system-name>,
<FRU Id> is not accessible.
Probable Indicates that the specified FRU does not seem to be present on the switch.
Cause
If the FRU is a WWN card, then default WWN and IP addresses are used for the switch.
Recommended
Reseat the FRU card.
Action
If the message persists, reboot or power cycle the switch.
Run the systemVerification command to verify that the switch does not have hardware problems. Refer
to the Fabric OS Command Reference for more information on this command.
If the message persists, replace the FRU.
Severity WARNING
9-10 Fabric OS Message Reference
Publication Number: 53-1000242-01