Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 400

58
SEC-1029
Recommended
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
Action
in the ready state. If a switch is in the error state, the database might not be correctly updated for that
specific switch.
Severity ERROR
SEC-1029
Message
<timestamp>, [SEC-1029], <sequence-number>,, ERROR, <system-name>,
Invalid character in <policy name>.
Probable Indicates that a corruption occurred during the distribution of the security database. This can occur only
Cause
when the primary FCS distributes the security database to the other switches in the fabric, then local
validation finds the error in the security database. This is a rare occurrence.
Recommended
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
Action in the ready state. If a switch is in the error state, the database might not be correctly updated for that
specific switch.
Severity ERROR
SEC-1030
Message
<timestamp>, [SEC-1030], <sequence-number>, ERROR, <system-name>,
The length of the name invalid.
Probable Indicates that a corruption occurred during the distribution of the security database. This can occur only
Cause
when the primary FCS distributes the security database to the other switches in the fabric, then local
validation finds the error in the security database. This is a rare occurrence.
Recommended
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
Action in the ready state. If a switch is in the error state, the database might not be correctly updated for that
specific switch.
Severity ERROR
SEC-1031
Message
<timestamp>, [SEC-1031], <sequence-number>,, WARNING, <system-
name>, Current security policy DB cannot be supported by standby.
CPs will go out of sync.
58-6 Fabric OS Message Reference
Publication Number: 53-1000242-01