Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 183

FCR-1048
Message
<timestamp>, [FCR-1048], <sequence-number>,, ERROR, <system-name>,
On EX port (<port number>) setting port <credit type> credits
failed.
Probable
Indicates the specified credit type was not set.
Cause
Recommended
Setting port credits failed. Run the portEnable command.
Action
If the problem persists try rebooting the switch.
If the message persists, collect switch information using the supportShow command, and contact your
switch service provider.
Severity
ERROR
FCR-1049
Message
<timestamp>, [FCR-1049], <sequence-number>,, ERROR, <system-name>,
EX port (<port number>) received an ELP command that is not
supported.
Probable
Indicates that an incoming ELP command was issued and it is not supported.
Cause
Recommended
Run the portEnable and portDisable commands to enable and disable the port.
Action
If the problem persists contact your switch service provider.
Severity
ERROR
FCR-1053
Message
<timestamp>, [FCR-1053], <sequence-number>,, WARNING, <system-
name>, Port <port number> was disabled, <disable reason>.
Probable
Indicates that the specified port was disabled because of a mismatched configuration parameter.
Cause
Recommended
Use the specified disable reason. Look for a possible configuration parameter mismatch between the
Action EX port and the switch at other end of the link.
Severity
WARNING
Fabric OS Message Reference
Publication Number: 53-1000242-01
18
FCR-1048
18-15