Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 165

Brocade fabric os message reference guide (53-1000242-01, november 2006)

Hide thumbs Also See for AA979A - StorageWorks SAN Switch 2/8V:

Table of Contents

FCPD System Messages

<timestamp>, [FCPD-1001], <sequence-number>,, WARNING, <system-

name>, Probing failed on <error string>

Indicates that an FCP switch probed devices on a loop port, and the probing failed on the either the

L_Port, AL_PA address, or the F_Port. For the AL_PA, the valid range is 00 through FF. The error sting

can be either:

L_Port port_number ALPA alpa_number

F_Port port_number

This can happen when the firmware on the device controller on the specified port has a defect. Check

with the device vendor for a firmware upgrade containing a defect fix.

The SilkWorm 4100 does not support private loop devices.

<timestamp>, [FCPD-1002], <sequence-number>,, WARNING, <system-

name>, port <port number>, bad R_CTL for fcp probing: 0x<R_CTL

Indicates that the response frame received on the specified port for a inquiry request contains an invalid

value in the routing control field.

This can happen only if the firmware on the device controller on the specified port has a defect. Check

with the device vendor for a firmware upgrade containing a defect fix.

Fabric OS Message Reference

Publication Number: 53-1000242-01