Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 554

79
SULB-1026
Recommended
Since the operation may have been started to repair the secondary partition, run the firmwareShow
Action
command to verify the versions. If the blade firmware version is still inconsistent with the active CP
firmware, firmwareDownload will be started automatically to the blade again. If the blade firmware is
the same as the active CP firmware, firmwareDownload has completed successfully on the blade.
Severity WARNING
SULB-1026
Message
AUDIT, <timestamp>, [SULB-1026], WARNING, FIRMWARE, <event-
initiator-details>, <event-location>, , Firmware commit operation
started on the blade in slot <Slot number>.
Probable firmwareCommit has started on the indicated blade. The operation may be a normal part of
Cause
firmwareDownload. It can also be started to repair the secondary partition of the blade if the secondary
partition is corrupted.
Recommended
No action is required.
Action
Severity
WARNING
SULB-1030
Message
AUDIT, <timestamp>, [SULB-1030], WARNING, FIRMWARE, <event-
initiator-details>, <event-location>, , The switch has rebooted
during relocating the internal firmware image.
Probable The error can be caused by unexpected disruption of firmwareDownload command, for exampling
Cause
powering the switch off and on in the middle of a firmwareDownload. This error can also be caused by
persistent storage hardware failure, or a software error.
Recommended
firmwareDownload process will continue after the switch is rebooted. So continue to run the
Action firmwareDownloadStatus command to monitor the progress. However, if this problem persists,
contact the service provider for further actions.
Severity WARNING
SULB-1034
Message
AUDIT, <timestamp>, [SULB-1034], ERROR, FIRMWARE, <event-initiator-
details>, <event-location>, , Firmwaredownload timed out.
79-12 Fabric OS Message Reference
Publication Number: 53-1000242-01