Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 59

Table 1-1
Command
portLogShowPort
portLogTypeDisable Disables an event from reporting to the port log. Port log events are described
portLogTypeEnable
saveCore
setVerbose
supportFtp
supportFfdc
supportSave
supportShow
syslogDIpAdd
syslogDIpRemove
syslogDIpShow
syslogdFacility
traceDump
traceFtp
traceTrig
Fabric OS Message Reference
Publication Number: 53-1000242-01
Viewing and Configuring System Message Logs
Commands Used to View or Configure the System Logs (Continued)
Description
Displays the port log of specified port, with page breaks.
by the portLogEventShow command.
Enables an event to report to the port log. Port log events are described by the
portLogEventShow command.
Saves or removes core files created by the kernel.
Sets the verbose level of a particular module within the Fabric OS.
Sets, clears, or displays support FTP parameters or a time interval to check the
FTP server.
Enables and disables FFDC (first failure data capture).
Collects RASLog, trace files, and supportShow (active CP only) information
for the local CP and then transfers the files to an FTP server. The operation can
take several minutes.
Executes a list of diagnostic and error display commands. This output is used
by your switch service provider to diagnose and correct problems with the
switch. The output from this command is very long.
Adds an IP address as a recipient of system messages.
Removes an IP address as a recipient of system messages.
Views the currently configured IP addresses that are recipients of system
messages.
Changes the syslogd facility.
Displays, initiates, or removes a Fabric OS module trace dump.
Displays, enables, or disables the trace auto-FTP or retrieves the trace dump
file.
Sets, removes, or displays trace triggers.
1
1-5