Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 229

Brocade fabric os message reference guide (53-1000242-01, november 2006)
Hide thumbs Also See for AA979A - StorageWorks SAN Switch 2/8V:
Table of Contents

Advertisement

FW-1160
Message
<timestamp>, [FW-1160], <sequence-number>,, INFO, <system-name>,
<Port Name>, <Label>, value has changed(High=<High value>, Low=<Low
value>). Current value is <Value> <Unit>.
Probable
Indicates that the number of link failures that the port experiences has changed. Link loss errors occur
Cause
when a link experiences a loss of signal and fails. Both physical and hardware problems can cause link
loss errors. Link loss errors frequently occur due to a loss of synchronization. Check for concurrent loss
of synchronization errors and, if applicable, troubleshoot them.
Recommended
Check both ends of your cable connection. Verify that the cable and SFPs are not faulty.
Action
Losses of synchronization commonly causes link failures. If you receive concurrent loss of
synchronization errors, troubleshoot the loss of synchronization.
Severity
INFO
FW-1161
Message
<timestamp>, [FW-1161], <sequence-number>,, INFO, <system-name>,
<Port Name>, <Label>, is below low boundary(High=<High value>,
Low=<Low value>). Current value is <Value> <Unit>.
Probable
Indicates that the number of link failures that the port experiences has fallen below the low boundary.
Cause
Link loss errors occur when a link experiences a loss of signal and fails. Both physical and hardware
problems can cause link loss errors. Link loss errors frequently occur due to a loss of synchronization.
Check for concurrent loss of synchronization errors and, if applicable, troubleshoot them. A low
number of link loss errors means that the switch is functioning normally.
Recommended
No action is required. Respond to this message as is appropriate to the particular policy of the end-user
Action
installation.
Severity
INFO
FW-1162
Message
<timestamp>, [FW-1162], <sequence-number>,, WARNING, <system-name>,
<Port Name>, <Label>, is above high boundary(High=<High value>,
Low=<Low value>). Current value is <Value> <Unit>.
Fabric OS Message Reference
Publication Number: 53-1000242-01
25
FW-1160
25-23

Advertisement

Table of Contents
loading

Table of Contents