Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 290

25
FW-1444
FW-1444
Message
<timestamp>, [FW-1444], <sequence-number>,, WARNING, <system-name>,
<FRU label> state has changed to <FRU state>.
Probable Indicates that the specified FRU's state has changed to "faulty".
Cause
Recommended Replace the FRU.
Action
Severity WARNING
FW-1445
Message
<timestamp>, [FW-1445], <sequence-number>,, INFO, <system-name>,
Four power supplies are now required for 2X redundancy, Switch
Status Policy values changed.
Probable
Indicates that the switch now requires 4 power supplies and previous Switch Status Policy parameters
Cause will be overwritten to reflect this. The presence of an AP blade means that more than one power supply
may be required to provide adequate power. So (even if the AP blade is powered down or removed) the
Switch Status policy values will now reflect the need for 4 power supplies to maintain full (2X)
redundancy.
Recommended No action required, unless there are fewer than 4 power supplies active in the chassis. If there are fewer
Action
than 4, insert additional power supplies so that there are 4 active.
Severity INFO
FW-1446
Message
<timestamp>, [FW-1446], <sequence-number>,, WARNING, <system-name>,
Four power supplies now required for 2X redundancy, not enforced by
Fabric Watch due to Switch Status Policy overridden by User.
Probable
Indicates that the switch now requires 4 power supplies for full (2X) redundancy, but the user has
Cause previously overridden the Switch Status Policy values pertaining to number of power supplies. So those
values will not be automatically changed. The default values with no AP blades are: 3 out of service
indicates switch status is DOWN, 0 indicates no checking for switch status MARGINAL. The default
values when an AP blade is or has been present are: 2 out of service indicates switch status is DOWN, 1
out of service indicates switch status is MARGINAL
25-84 Fabric OS Message Reference
Publication Number: 53-1000242-01