Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 551

Upgrade State
SUS_PEER_FWC_BEGIN
SUS_PEER_FS_CHECK1
SUS_FINISH
SUS_COMMIT
Recommended Run the firmwareDownloadStatus command for more information.
Action
In a director, when firmwareDownload fails, the command will synchronize the firmware on the two
partitions of each CP by starting a firmware commit operation. Wait until this operation completes
(about 10 minutes) before attempting another firmwareDownload.
In a director, when firmwareDownload fails, the two CPs may end up with different versions of
firmware and they may not gain HA sync. In that case, run firmwareDownload single mode (-s) to
upgrade the firmware on the standby CP to the same version as the active CP. Then retry
firmwareDownload to download the desired version of firmware onto the CPs.
Refer to the Fabric OS Administrator's Guide for troubleshooting information.
Severity
INFO
SULB-1010
Message
AUDIT, <timestamp>, [SULB-1010], INFO, FIRMWARE, <event-initiator-
details>, <event-location>, , Firmwarecommit failed
(status=0x<error code>).
Probable
Indicates that the firmwareCommit failed. The error code provides debugging information. See
Cause Table 79-3
Recommended
Run the firmwareCommit command with "-d" option to provide more debugging information.
Action
Severity
INFO
SULB-1017
Message
AUDIT, <timestamp>, [SULB-1017], ERROR, FIRMWARE, <event-initiator-
details>, <event-location>, , Firmwaredownload failed in slot <Slot
number>.
Probable
Indicates that the firmwareDownload failed in the indicated blade. The error can be caused by
Cause
inconsistent AP blade firmware stored on the active CP. It can also be caused by persistent storage
hardware failure.
Fabric OS Message Reference
Publication Number: 53-1000242-01
for more information.
Code
0x32
0x33
0x34
0x35
79
SULB-1010
79-9