Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 90

2
AUTH-1036
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
ERROR
AUTH-1036
Message
<timestamp>, [AUTH-1036], <sequence-number>,, ERROR, <system-name>,
Invalid state <state value> for <authentication phase>: port <port
number>
Probable Indicates that the switch received an unexpected authentication message.
Cause
Recommended Usually this problem is transient. The authentication might fail.
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
ERROR
AUTH-1037
Message
<timestamp>, [AUTH-1037], <sequence-number>,, ERROR, <system-name>,
Failed to <operation type> response for <authentication message>:
init_len <data length>, resp_len <data length>, port <port number>.
Probable Indicates that a DH-CHAP authentication operation failed on the specified port due to mismatched
Cause
response values between two entities.
Recommended The error might indicate that an invalid entity tried to connect to the switch. Check the connection port
Action
for a possible security attack.
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
2-12 Fabric OS Message Reference
Publication Number: 53-1000242-01