Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 123

Brocade fabric os message reference guide (53-1000242-01, november 2006)
Hide thumbs Also See for AA979A - StorageWorks SAN Switch 2/8V:
Table of Contents

Advertisement

EM-1005
Message
<timestamp>, [EM-1005], <sequence-number>, FFDC, CRITICAL, <system-
name>, <FRU Id> has faulted. Sensor(s) above maximum limits
Probable
Indicates that a blade in the specified slot or the switch (for nonbladed switches) is being shut down for
Cause
environmental reasons; its temperature or voltage is out of range.
Recommended
Check the environment and make sure the room temperature is within the operational range of the
Action
switch. Use the fanShow command to verify fans are operating properly. Make sure there are no
blockages of the airflow around the chassis. If the temperature problem is isolated to the blade itself,
replace the blade.
Voltage problems on a blade are likely a hardware problem on the blade itself; replace the blade.
Severity
CRITICAL
EM-1006
Message
<timestamp>, [EM-1006], <sequence-number>, FFDC, CRITICAL, <system-
name>, <FRU Id> has faulted. Sensor(s) below minimum limits
Probable
Indicates that the sensors show the voltage is below minimum limits. The switch or specified blade is
Cause
being shut down for environmental reasons; the voltage is too low.
Recommended
If this problem occurs on a blade, it usually indicates a hardware problem on the blade; replace the
Action
blade.
If this problem occurs on a switch, it usually indicates a hardware problem on the main board; replace
the switch.
Severity
CRITICAL
EM-1007
Message
<timestamp>, [EM-1007], <sequence-number>, FFDC, CRITICAL, <system-
name>, <FRU Id> is being reset. Sensor(s) has exceeded max limits
Probable
Indicates that the voltage on a switch has exceeded environmental limits. A reset is sent to the faulty slot
Cause
or the switch for nonbladed switches.
Recommended
There is most likely a voltage hardware problem on the blade or motherboard of the switch.
Action
For the SilkWorm 24000 and 48000, replace the blade FRU.
For the SilkWorm 3900 replace the motherboard FRU.
Fabric OS Message Reference
Publication Number: 53-1000242-01
9
EM-1005
9-3

Advertisement

Table of Contents
loading

Table of Contents