Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 414

58
SEC-1080
SEC-1080
Message
<timestamp>, [SEC-1080], <sequence-number>,, ERROR, <system-name>,
Operation denied. Please, use secModeEnable command.
Probable Indicates that there has been a corruption during the distribution of the security database. This can only
Cause
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurrence.
Recommended
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
Action in the ready state. If a switch is in the error state, the database might not be correctly updated for that
specific switch.
Severity ERROR
SEC-1081
Message
<timestamp>, [SEC-1081], <sequence-number>,, ERROR, <system-name>,
Entered a name for a DCC policy ID that was not unique.
Probable Indicates that the DCC policy name given in the secPolicyCreate command was the same as another
Cause
DCC policy.
Recommended Make sure that the DCC policy name has a unique alpha-numeric string, and run the secPolicyCreate
Action
command again.
Severity
ERROR
SEC-1082
Message
<timestamp>, [SEC-1082], <sequence-number>,, ERROR, <system-name>,
Failed to create <policy name> policy.
Probable
Indicates that the security policy was not created due to faulty input or low resources.
Cause
Recommended
Use proper syntax when creating policies. If the security database is too large, you must delete other
Action members within the database before adding new members to a policy.
Severity
ERROR
58-20 Fabric OS Message Reference
Publication Number: 53-1000242-01