Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 352

44
MS-1003
Recommended
The recommended actions are as follows:
Action
•
<No Resp for GCAP from>
No action is required.
•
<GCAP sup but not PL by>
Set the flag for the MS Platform Service.
•
<GCAP Rejected (reason =BUSY) by>
Run the firmwareDownload command to upgrade the firmware level on the switch to a level that
supports RCS. RCS is supported in Fabric OS v2.6, v3.1 and greater, and v4.1 and greater.
•
<Reject EXGPLDB from>
Wait a few minutes and try the command again.
Severity
INFO
MS-1003
Message
<timestamp>, [MS-1003], <sequence-number>,, INFO, <system-name>, MS
detected Unstable Fabric(<message string><domain number>).
Probable Indicates that MS detected an unstable fabric; the command or operation might not be successfully
Cause completed. This message is often transitory.
The message string can be one of the following:
•
<DOMAIN_INVALID for a req from>
The domain is invalid for a request.
•
<No WWN for>
Unable to acquire the World Wide Name (WWN) for the corresponding domain.
The domain number is the target domain that caused error.
Recommended The fabric might be reconfiguring, forming, or merging. Wait a few minutes and try the operation again.
Action
Run the fabricShow command or the secFabricShow command to verify that the number of domains
matches the Management Server known domains.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
INFO
MS-1004
Message
<timestamp>, [MS-1004], <sequence-number>,, INFO, <system-name>, MS
detected ONLY 1 Domain(d=<domain in local resource>).
Probable Indicates that MS detected an unstable count of domains in its own local resource.
Cause
44-2 Fabric OS Message Reference
Publication Number: 53-1000242-01