Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 417

SEC-1089
Message
<timestamp>, [SEC-1089], <sequence-number>,, ERROR, <system-name>,
Policy name <policy name> was not found.
Probable Indicates that the security policy name in the secPolicyAdd command does not exist.
Cause
Recommended
Create the appropriate security policy first, then use its name in the secPolicyAdd command to add new
Action
members.
Severity
ERROR
SEC-1090
Message
<timestamp>, [SEC-1090], <sequence-number>,, ERROR, <system-name>,
SCC list contains FCS member. Please remove member from the FCS
policy first.
Probable Indicates that there has been a corruption during the distribution of the security database. This can only
Cause
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurrence.
Recommended
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
Action
in the ready state. If a switch is in the error state, the database might not be correctly updated for that
specific switch.
Severity ERROR
SEC-1091
Message
<timestamp>, [SEC-1091], <sequence-number>,, ERROR, <system-name>,
No policy to remove.
Probable Indicates that the specified policy member does not exist or the policy itself does not exist.
Cause
Recommended Verify that the security policy name or member ID is correct.
Action
Severity ERROR
Fabric OS Message Reference
Publication Number: 53-1000242-01
58
SEC-1089
58-23