Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 87

Probable
Indicates that the authentication process failed because the system is low on memory.
Cause
Data type is the payload or structure that failed to get memory. Operation phase specifies which
operation of a particular authentication phase failed.
Recommended
Usually this problem is transient. The authentication might fail.
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
AUTH-1029
Message
<timestamp>, [AUTH-1029], <sequence-number>,, ERROR, <system-name>,
Failed to get <data type> for <message phase> message: port <port
number>, retval <error code>
Probable
Indicates that the authentication process failed to get a particular authentication value at certain phase.
Cause
Data type is the payload or structure that failed to get memory.
Recommended
Usually this problem is transient. The authentication might fail.
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
AUTH-1030
Message
<timestamp>, [AUTH-1030], <sequence-number>,, ERROR, <system-name>,
Invalid message code for <message phase> message: port <port
number>
Probable
Indicates the receiving payload does not have valid message code for a particular authentication phase.
Cause
Recommended
Usually this problem is transient. The authentication might fail.
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
Fabric OS Message Reference
Publication Number: 53-1000242-01
2
AUTH-1029
2-9