Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 451

SEC-1311
Message
<timestamp>, [SEC-1311], <sequence-number>,, ERROR, <system-name>,
Security mode cannot be enabled because one or more of the password
policies is not set to default value.
Probable
Indicates that the security enable failed on the fabric because one or more switches in the fabric have
Cause
password policies that are not set to the default value.
Recommended
Verify that the security event was planned.
Action
If the security event was planned, run the passwdCfg --setDefault command on each switch in the
fabric to set the password policies to the default value. Then verify with passwdCfg --show that passwd
policies are set to the defaults on all switches and retry the secModeEnable command.
Severity ERROR
SEC-1312
Message
<timestamp>, [SEC-1312], <sequence-number>,, INFO, <system-name>,
<MESG Message>.
Probable
Indicates that the passwdCfg parameters changed.
Cause
Recommended
Verify that the security event was planned. If the security event was planned, no action is required. If the
Action security event was not planned, take appropriate action as defined by your enterprise security policy.
Severity
INFO
SEC-1313
Message
<timestamp>, [SEC-1313], <sequence-number>,, INFO, <system-name>,
The passwdcfg parameters were set to default values.
Probable
Indicates that the passwdCfg parameters were set to default values.
Cause
Recommended
Verify that the security event was planned. If the security event was planned, no action is required. If the
Action security event was not planned, take appropriate action as defined by your enterprise security policy.
Severity
INFO
Fabric OS Message Reference
Publication Number: 53-1000242-01
58
SEC-1311
58-57