Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 109

BM System Messages
BM-1001
Message
<timestamp>, [BM-1001], <sequence-number>,, ERROR, <system-name>,
BM protocol version <Protocol version> in slot <Slot number>
Probable
Indicates that the software running on the CP cannot communicate with the AP blade in the indicated
Cause
slot, in order to determine AP blade's firmware version. This can be due to one of the following:
•
The CP blade is running a much newer version than the AP blade
•
The CP blade is running a much older version than the AP blade
Recommended
The problem can be corrected by changing the version of firmware on the CP or AP blades. The
Action firmware version on the CP blade can be changed using the firmwareDownload command. Refer to the
release notes to determine whether a non-disruptive firmwareDownload is supported between the
versions. As the AP and CP blades cannot communicate, it is not possible to load new firmware on the
AP blade. If required, send the AP blade back to the factory to get a new firmware version installed.
Severity ERROR
BM-1002
Message
<timestamp>, [BM-1002], <sequence-number>,, INFO, <system-name>,
Connection established between CP and blade in slot <Slot number>
Probable The CP has established a connection to the BP and can communicate.
Cause
Recommended
No action is required.
Action
Severity
INFO
Fabric OS Message Reference
Publication Number: 53-1000242-01
Chapter
5
5-1