Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 154

12
FABS-1005
Probable
Indicates that an operation has been interrupted by a signal. This is usually an internal Fabric OS
Cause
problem or file corruption.
Recommended
Reboot or power cycle the switch.
Action
Severity
WARNING
FABS-1005
Message
<timestamp>, [FABS-1005], <sequence-number>,, WARNING, <system-
name>, <Function name and description of problem> (<ID type>= <ID
number>)
Probable Indicates that an unsupported operation has been requested. This is usually an internal Fabric OS
Cause
problem or file corruption. The possible values for function name and description of problem are:
fabsys_write: Unsupported write operation: process xxx
where "xxx" is the process ID (PID), which could be any whole number.
Recommended Reboot or power cycle the active CP (for modular systems) or the switch (for single-board systems).
Action
If the message persists, run the firmwareDownload command to update the firmware.
Severity WARNING
FABS-1006
Message
<timestamp>, [FABS-1006], <sequence-number>,, WARNING, <system-
name>, <Function name and description of problem>: object <object
type id> unit <slot>
Probable
Indicates that there is no device in the slot with the specified object type ID in the system module
Cause record. This could indicate that a serious Fabric OS data problem on the switch. The possible values for
function name and description of problem are:
•
setSoftState: bad object
•
setSoftState: invalid type or unit
•
media_sync: Media oid mapping failed
•
fabsys_media_i2c_op: Media oid mapping failed
•
fabsys_media_i2c_op: obj is not media type
•
media_class_hndlr: failed sending media state to blade driver
Recommended If the message is isolated, monitor the error messages on the switch. If the error is repetitive or if the
Action fabric failed, fail over or reboot the switch.
12-2 Fabric OS Message Reference
Publication Number: 53-1000242-01