Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 142

11
FABR-1003
FABR-1003
Message
<timestamp>, [FABR-1003], <sequence-number>,, WARNING, <system-
name>, port <port number>: ILS <command> bad size <payload size>,
wanted <expected payload size>
Probable
Indicates that an internal link service (ILS) information unit of invalid size has been received. The
Cause
neighbor switch has sent an invalid sized payload.
Recommended
Investigate the neighbor switch for problems. Run the errShow command on the neighbor switch to
Action view the error log for additional messages.
Check for a faulty cable or deteriorated SFP. Replace the cable or SFP if necessary.
Run the portLogDumpPort command on both the receiving and transmitting ports.
Run the fabStateShow command on both the receiving and transmitting switches.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING
FABR-1004
Message
<timestamp>, [FABR-1004], <sequence-number>,, WARNING, <system-
name>, port: <port number>, req iu: 0x<address of IU request sent>,
state: 0x<command sent>, resp iu: 0x<address of response IU
received>, state 0x<response IU state>, <additional description>
Probable Indicates that the information unit response was invalid for the specified command sent. The fabric
Cause
received an unknown response. This message is rare and usually indicates a problem with the Fabric OS
kernel.
Recommended
If this message is due to a one-time event because of the incoming data, the system will discard the
Action frame. If it is due to problems with the kernel, the system will recover by performing a failover.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING
11-2 Fabric OS Message Reference
Publication Number: 53-1000242-01