Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 137

Brocade fabric os message reference guide (53-1000242-01, november 2006)

Hide thumbs Also See for AA979A - StorageWorks SAN Switch 2/8V:

Table of Contents

<timestamp>, [EM-1061], <sequence-number>,, WARNING, <system-name>,

Synchronization halted. Remove all blades of type <Blade Type Id> or

upgrade your standby CP, then reboot or run haSyncStart.

A blade in the system is not supported by the release on the standby CP.

Please remove all blades of this type or upgrade your standby CP. Once an appropriate action is taken,

this CP must be rebooted or haSyncStart must be run successfully. Until this is done, the system will

remain out of synchronization.

<timestamp>, [EM-1062], <sequence-number>,, CRITICAL, <system-

name>, Blade in slot <Slot Id> faulted as it exceeds the maximum

support limit of <Limit> blades with Blade ID <Blade Type Id> in the

Too many blades of a particular type are in the system.

Please remove the faulted blade.

<timestamp>, [EM-1063], <sequence-number>,, CRITICAL, <system-

name>, Blade in slot <Slot Id> faulted because it exceeds the

maximum support limit of <Limit> blades with Blade IDs <Applicable

blade Type IDs> in the chassis.

Too many blades of a set of particular types are in the system.

Please remove the faulted blade.

Fabric OS Message Reference

Publication Number: 53-1000242-01