Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 421

SEC-1101
Message
<timestamp>, [SEC-1101], <sequence-number>,, ERROR, <system-name>,
Failed to enable security on all switches. Please retry later.
Probable Indicates that the security enable failed on the fabric because one or more switches in the fabric are
Cause
busy.
Recommended Verify that the security event was planned. If the security event was planned, run the secFabricShow
Action
command to verify that all switches in the fabric are in the ready state. When all switches are in the
ready state, retry the operation.
Severity
ERROR
SEC-1102
Message
<timestamp>, [SEC-1102], <sequence-number>,, ERROR, <system-name>,
Fail to download <security data>.
Probable Indicates that the switch failed to download certificate, security database, or policies. This can happen
Cause
when switch does not get enough resources to complete the operation, fabric has not stabilized, or
policy database is an invalid format.
Recommended
Wait for fabric to become stable and then retry the operation. If the policy database is in an illegal
Action
format (with configDownload), correct the format and retry the operation.
Severity
ERROR
SEC-1104
Message
<timestamp>, [SEC-1104], <sequence-number>,, ERROR, <system-name>,
Fail to get primary <Certificate or public key>.
Probable
Indicates that the switch failed to get either the primary certificate or a primary public key.
Cause
Recommended Verify that the primary switch has a valid certificate installed and retry the operation. If a valid
Action certificate is not installed, install a certificate by following the procedure specified in the Secure Fabric
OS Administrator's Guide.
Severity
ERROR
Fabric OS Message Reference
Publication Number: 53-1000242-01
58
SEC-1101
58-27