Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 83

AUTH-1013
Message
<timestamp>, [AUTH-1013], <sequence-number>,, WARNING, <system-
name>, Can not perform authentication request message: port <port
number>, message code <message code>
Probable
Indicates that the system is running low on resources when receiving an authentication request.
Cause
Recommended
Usually this problem is transient. The authentication might fail.
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING
AUTH-1014
Message
<timestamp>, [AUTH-1014], <sequence-number>, FFDC, ERROR, <system-
name>, Invalid port value to <operation>: port <port number>
Probable Indicates an internal problem with the Secure Fabric OS.
Cause
Recommended
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
Action
switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
AUTH-1017
Message
<timestamp>, [AUTH-1017], <sequence-number>,, ERROR, <system-name>,
Invalid value to start authentication request: port <port number>,
opcode <operation code>
Probable Indicates an internal problem with the Secure Fabric OS.
Cause
Fabric OS Message Reference
Publication Number: 53-1000242-01
2
AUTH-1013
2-5