Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 420

58
SEC-1098
SEC-1098
Message
<timestamp>, [SEC-1098], <sequence-number>,, ERROR, <system-name>,
No <active or defined> FCS list.
Probable Indicates that the specified policy could not be found.
Cause
Recommended
Run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command
Action
and contact your switch service provider.
Severity
ERROR
SEC-1099
Message
<timestamp>, [SEC-1099], <sequence-number>,, ERROR, <system-name>,
Please enable your switch before running secModeEnable.
Probable
Indicates that there has been a corruption during the distribution of the security database. This can only
Cause occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurrence.
Recommended Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
Action
in the ready state. If a switch is in the error state, the database might not be correctly updated for that
specific switch.
Severity
ERROR
SEC-1100
Message
<timestamp>, [SEC-1100], <sequence-number>,, ERROR, <system-name>,
FCS switch present. Command terminated.
Probable
Indicates that there has been a corruption during the distribution of the security database. This can only
Cause occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurrence.
Recommended Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
Action
in the ready state. If a switch is in the error state, the database might not be correctly updated for that
specific switch.
Severity
ERROR
58-26 Fabric OS Message Reference
Publication Number: 53-1000242-01