Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 549

Error Message
"The pre-install script failed."
"The platform option is not supported. Run chassisConfig to reset the option first
and then try firmwareDownload."
"Failed to install RPM package."
"Cannot downgrade directly to this version. Downgrade to an intermediate version
first and then download the desired version."
"Cannot download 5.1 because Device Based Routing policy is not supported by 5.1.
Use aptPolicy to change the routing policy before proceeding."
"Invalid RPM package. Please reload firmware packages on the file server."
"Cannot downgrade due to presence of blade type 17. Remove or power off these
blades before proceeding."
"Cannot downgrade due to presence of blade type 24. Remove or power off these
blades before "
"Cannot downgrade due to presence of long-distance ports in LS mode. Please
remove these settings before proceeding."
"Network is not reachable. Please verify the IP address of the server is correct."
The following section explains the causes of some common error messages:
0x12 - Unable to access the required package list file. Check the firmwareDownload help page for a
list of possible failure reasons. The cause of this error may be that the package list file (.plist) name has
not been specified properly. You need to specify the fully qualified path and file name for the package
list file, excluding the /SWBDxx directory name. For example, if /dist/SWBD42/release.plist is a fully
qualified path and file name, you need to specify /dist/release.plist as the package list file. The error can
also be caused by one of the following conditions:
•
•
•
•
•
•
•
0x15 - Failed to download RPM package. If this error occurs immediately after firmwareDownload is
started, the firmware on the switch may be two releases older than the requested firmware.
Firmwaredownload supports firmware upgrades within two feature releases (a feature release is
indicated by a major number and a minor number, for example, X.Y). The following are major upgrade
versions for the Fabric OS: v4.0, v4.1, v4.2, v4.4, v5.0, and v5.1. In this case, you will need to upgrade
to an intermediate version before downloading the desired version. If this error occurs in the middle of
firmwaredownload, the firmware in the file server may be corrupted or there may be a temporary
network issue. In this case, retry the firmwaredownload command. If the problem persists, contact your
system administrator.
Fabric OS Message Reference
Publication Number: 53-1000242-01
host is not known to the switch.
host cannot be reached by the switch.
user does not have permission on \fIhost\fR.
pfile does not exist on host.
pfile is not in the right format.
the FTP server is not running on host.
Platform does not support indicated firmware.
79
SULB-1009
Error Code
0x29
0x2a
0x2b
0x2c
0x2d
0x2e
0x2f
0x30
0x31
0x32
79-7