Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 544

79
SULB-1003
SULB-1003
Message
AUDIT, <timestamp>, [SULB-1003], INFO, FIRMWARE, <event-initiator-
details>, <event-location>, , Firmwarecommit has started.
Probable Indicates that the firmwareCommit command has been entered.
Cause
Recommended No action is required. Run the firmwareDownloadStatus command for more information.
Action
Severity INFO
SULB-1009
Message
AUDIT, <timestamp>, [SULB-1009], INFO, FIRMWARE, <event-initiator-
details>, <event-location>, , Firmwaredownload command failed.
status: 0x<status code>, error: 0x<error code>.
Probable
Indicates that the firmwareDownload command failed. The additional status code and error code
Cause provide debugging information.
Table 79-1
in this RASLOG message. They are listed for the sake of completeness.
Table 79-1
Status Message
"firmwareDownload sanity check failed."
"Sanity check failed because system is non-redundant."
"Sanity check failed because firmwareDownload is already in progress."
"Sanity check failed because FABRIC OS is disabled on Active CP."
"Sanity check failed because HAMD is disabled on Active CP."
"Sanity check failed because firmwareDownload is already in progress."
"Sanity check failed because FABRIC OS is disabled on Standby CP."
"Sanity check failed because HAMD is disabled on Standby CP."
"firmwareDownload failed on Standby CP."
"firmwareDownload failed on Standby CP."
"firmwareDownload failed on Standby CP."
"firmwareCommit failed on Standby CP."
"firmwareDownload failed."
79-2
lists firmwareDownload status messages and status codes. Some of them will not show up
Status Messages and Status Codes
Status Code
0x30
0x31
0x32
0x33
0x34
0x35
0x36
0x37
0x40
0x41
0x42
0x43
0x44
Fabric OS Message Reference
Publication Number: 53-1000242-01