Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 424

58
SEC-1112
SEC-1112
Message
<timestamp>, [SEC-1112], <sequence-number>,, ERROR, <system-name>,
FCS list must be the first entry in the Active Security policies,
and the same as the current active FCS list in the switch.
Probable
Indicates that either a security policy download is attempted with an active policy that does not have the
Cause
FCS policy as the first policy or the FCS policy is not same as the current FCS policy on the switch.
Recommended
Make sure that the new FCS policy is the same as the current FCS policy on the switch.
Action
Severity
ERROR
SEC-1115
Message
<timestamp>, [SEC-1115], <sequence-number>,, ERROR, <system-name>,
No primary FCS to failover.
Probable
Indicates that during an attempted secFcsFailover, no primary FCS is present in the fabric.
Cause
Recommended
Run the secFabricShow command to verify that all switches in fabric are in the ready state. When all
Action switches are in the ready state, retry the operation.
Severity ERROR
SEC-1116
Message
<timestamp>, [SEC-1116], <sequence-number>,, ERROR, <system-name>,
Fail to commit failover.
Probable Indicates that there has been a corruption during the distribution of the security database. This can only
Cause
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurrence.
Recommended
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
Action in the ready state. If a switch is in the error state, the database might not be correctly updated for that
specific switch.
Severity ERROR
58-30 Fabric OS Message Reference
Publication Number: 53-1000242-01