Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 511

Probable
Indicates that the zone database size is greater than the limit allowed by the fabric. The limit of the zone
Cause
database size depends on the lowest level switch in the fabric. Older switches have less memory and
force a smaller zone database for the entire fabric.
Recommended Edit the zone database to keep it within the allowable limit for the specific switches in your fabric. Refer
Action to the Fabric OS Administrator's Guide for information on the zone database sizes supported for each
switch.
Severity
WARNING
ZONE-1029
Message
<timestamp>, [ZONE-1029], <sequence-number>,, WARNING, <system-
name>, Restoring zone cfg from flash failed - bad config saved to
<config file name> [<return code>]
Probable
Indicates that the zone configuration restored from the flash was faulty.
Cause
Recommended This error will save the faulty zone configuration in the zoned core file directory. Run the saveCore
Action command to save the file.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
WARNING
ZONE-1030
Message
<timestamp>, [ZONE-1030], <sequence-number>,, WARNING, <system-
name>, Converting the zone db for PID format change failed
Probable
Indicates that the current zone database could not be converted to reflect the PID format change. Most
Cause likely this is caused by the size of the zone database.
Recommended
Change the PID format back to its original format. Reduce the size of the zone database. Then you can
Action change the PID format to the requested format.
Severity
WARNING
Fabric OS Message Reference
Publication Number: 53-1000242-01
73
ZONE-1029
73-9