Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 422

58
SEC-1105
SEC-1105
Message
<timestamp>, [SEC-1105], <sequence-number>,, ERROR, <system-name>,
Fail to disable secure mode on all switches.
Probable Indicates that the switch failed to disable security in the fabric. This could happen if the switch cannot
Cause
get the required resources to complete the command, and sending to a remote domain fails or the remote
domain returns an error.
Recommended
Run the secFabricShow to verify that all switches in the fabric are in the ready state. Retry the
Action command when all switches are READY.
Severity
ERROR
SEC-1106
Message
<timestamp>, [SEC-1106], <sequence-number>,, ERROR, <system-name>,
Failed to sign message data.
Probable
Indicates that some PKI objects on the switch are not in a valid state, and a signature operation failed.
Cause
Recommended
Run the pkiShow command and verify that all PKI objects exist on the switch. If a failure to validate
Action PKI objects occurs, follow the steps for re-creating PKI objects outlined in the Secure Fabric OS
Administrator's Guide.
Severity
ERROR
SEC-1107
Message
<timestamp>, [SEC-1107], <sequence-number>,, INFO, <system-name>,
Stamp is 0.
Probable
Indicates that there has been a corruption during the distribution of the security database. This can only
Cause
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurrence.
Recommended Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
Action in the ready state. If a switch is in the error state, the database might not be correctly updated for that
specific switch.
Severity
INFO
58-28 Fabric OS Message Reference
Publication Number: 53-1000242-01