Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 136

9
EM-1058
EM-1058
Message
<timestamp>, [EM-1058], <sequence-number>,, WARNING, <system-name>,
Switch gets reset:<Fault reason>
Probable The switch is automatically reset due to known resetable transient errors, such as bloom parity. error.
Cause
Recommended
No action is required if the switch does not reach the reset threshold for the switch/blade. If the reset
Action
threshold is reached on the switch/blade, the switch/blade will be faulted and should be replaced.
Severity
WARNING
EM-1059
Message
<timestamp>, [EM-1059], <sequence-number>, FFDC, CRITICAL, <system-
name>, Incompatible unit in <FRU Id> faulted
Probable
Indicates that a FRU inserted in the specified slot is not compatible with the switch software. The blade
Cause will not be used.
Recommended
Replace the blade. Make sure the replacement is compatible with your switch type.
Action
Severity CRITICAL
EM-1060
Message
<timestamp>, [EM-1060], <sequence-number>,, WARNING, <system-name>,
Stopping synchronization of the system due to blade incompatibility
with software version on standby CP.
Probable
A blade in the system is not supported by the release on the standby CP.
Cause
Recommended
Please remove all blades of this type or upgrade your standby CP. Once an appropriate action is taken,
Action this CP must be rebooted or haSyncStart must be run successfully. Until this is done, the system will
remain out of synchronization.
Severity WARNING
9-16 Fabric OS Message Reference
Publication Number: 53-1000242-01