Brocade Communications Systems AA979A - StorageWorks SAN Switch 2/8V Reference Manual page 95

BL-1006
Message
<timestamp>, [BL-1006], <sequence-number>,, INFO, <system-name>,
Blade <slot number> NOT faulted. Peer blade <slot number>
experienced abrupt failure.
Probable
Indicates that the errors (mostly synchronization errors) on this blade are harmless. Probably, the
Cause
standby CP blade connected to the active CP blade has experienced transitory problems.
Recommended
Verify that the standby CP is healthy. If the standby CP was removed or faulted by user intervention, no
Action action is required.
Severity
INFO
BL-1007
Message
<timestamp>, [BL-1007], <sequence-number>,, WARNING, <system-name>,
blade #<blade number>: blade state is inconsistent with EM.
bl_cflags 0x<blade control flags>, slot_on <slot_on flag>, slot_off
<slot_off flag>, faulty <faulty flag>, status <blade status>
Probable
Indicates that a failover occurred while a blade was initializing on the previously active CP.
Cause
Recommended
No action is required. The blade is reinitialized. Because reinitializing a blade is a disruptive operation
Action and can stop I/O traffic, you might have to stop and restart the traffic during this process.
Severity
WARNING
BL-1008
Message
<timestamp>, [BL-1008], <sequence-number>, FFDC, CRITICAL, <system-
name>, Slot <slot number> control-plane failure. Expected value:
0x<value 1>, Actual: 0x<value 2>
Probable Indicates that the blade has experienced a hardware failure or was removed without following the
Cause
recommended removal procedure.
Recommended Make sure that the blade is seated correctly.
Action
If the blade is seated correctly, reboot or power cycle the blade.
Run the systemVerification command to verify that the blade does not have hardware problems. Refer
to the Fabric OS Command Reference for more information on this command.
Fabric OS Message Reference
Publication Number: 53-1000242-01
3
BL-1006
3-3