Chapter 2 Polarization Mode Dispersion Measurement
Performing a PMD measurement
Loading a configuration file
To load the configuration file to be used for PMD test:
1
Press Setup key.
2
Press
3
In the Explorer, select the desired file configuration and press Load.
A beep is emitted to validate the selection of the configuration file.
The software automatically brings you back to setup page.
NOTE
Most of the configuration files are available into the Platform in disk/con-
fig/PMD.
Performing a PMD measurement
The following modules apply:
•
ODM V2 Module
Handheld or module broadband sources can be used to perform PMD measurements:
•
OBS-500
•
OBS-550
•
81BBS2A
The following procedure considers the use of an OBS-5xx type source.
Remote operator
1
Inspect and clean connectors with appropriate methods as described in IEC
61300-3-35.
2
Connect the fiber under test to the optical connector of the broadband source
using required mating solution such as a fiber patchcord.
3
Press the O
4
Press the "Active" button of the OBS-5x0 to activate the source transmission.
20
Load
Config. key
/O
button to switch on the OBS-5XX broadband source.
N
FF
User Manual
.
700MAN902 Rev. 000