Honda Accord 2008 Manual page 434

07/11/02 09:04:07 61TA0000_110_0115
20. Remove the rocker arm oil pressure switch
(see page 11-329), (PZEV model: rocker arm oil
pressure switch A (see page 11-330)).
21. Attach the special tools to the rocker arm oil control
valve as shown, then attach the rocker arm oil
pressure switch (A) in the pressure gauge adapter
(B).
All models except PZEV
＊０１
07406-0070301
PZEV model
＊０２
07406-0070301
07406-0020201 or
07MAJ-PY4011A and
07MAJ-PY40120
A
22 N·m
(2.2 kgf·m,
16 lbf·ft)
B
07NAJ-P07010A
07JAZ-S5AA200
07406-0020201 or
07MAJ-PY4011A and
07MAJ-PY40120
A
22 N·m
(2.2 kgf·m,
16 lbf·ft)
B
07NAJ-P07010A
07JAZ-S5AA200
22. Reconnect the rocker arm oil pressure switch
(rocker arm oil pressure switch A) 2P connector.
23. Start the engine. Hold the engine speed at
3,000 rpm without load (A/T in P or N, M/T in
neutral) until the radiator fan comes on, then let it
idle.
24. Check the oil pressure at engine speeds of
1,000 rpm and 2,000 rpm.
Is the oil pressure below 49 kPa ( 0.5 kgf / cm ,
7 psi)?
−
YES Check for air in the fuel line, then go to step
25.
NO − Inspect the VTEC system, then go to step 25.
25. Turn the ignition switch to ON (II).
26. Reset the ECM/PCM with the HDS.
27. Clear the CKP pattern with the HDS.
28. Do the ECM/PCM idle learn procedure (see page
11-343).
29. Do the CKP pattern learn procedure (see page 11-5).
2
(cont'd)
11-115