Virtual Lan (Vlan) Commands; Default Vlan-Id - Dell Z9500 Reference Manual

Version
7.5.1.0
6.5.1.0
Example
Dell#show mac learning-limit
Interface
Slot/port
Te 1/1
Te 1/2
Dell#show mac learning-limit interface tengigabithethernet 1/1
Interface
Slot/port
Te 1/1

Virtual LAN (VLAN) Commands

The following commands configure and monitor virtual LANs (VLANs). VLANs are a virtual interface and
use many of the same commands as physical interfaces.
You can configure an IP address and Layer 3 protocols on a VLAN called Inter-VLAN routing. FTP, TFTP,
ACLs and SNMP are not supported on a VLAN.
Occasionally, while sending broadcast traffic over multiple Layer 3 VLANs, the VRRP state of a VLAN
interface may continually switch between Master and Backup.
NOTE: For more information, refer to
portmode hybrid in the

default vlan-id

Specify a VLAN as the Default VLAN.
Z9500
Syntax
default vlan-id vlan-id
To remove the default VLAN status from a VLAN and VLAN 1 does not exist, use the
no default vlan-id vlan-id syntax.
Parameters
vlan-id
Defaults The Default VLAN is VLAN 1.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
1120
Description
Added support for the violate-action and detail
options.
Added support for Port Channel.
Learning Dynamic
Limit MAC count
10 0
5 0
Learning Dynamic
Limit MAC count
10 0
VLAN Stacking
Interfaces chapter.
Enter the VLAN ID number of the VLAN to become the new
Default VLAN. The range is from 1 to 4094. The default is 1.
Static Unknown SA
MAC count Drops
0 0
0 0
Static Unknown SA
MAC count Drops
0 0
and VLAN-related commands, such as
Layer 2