Configuring Mac-Based Vlans Using Snmp; Displaying Information About Mac-Based Vlans; Displaying The Mac-Vlan Table; Displaying The Mac-Vlan Table For A Specific Mac Address - Dell PowerConnect B-FCXs Configuration Manual

Configuring MAC-based VLANs using SNMP

Several MIB objects have been developed to allow the configuration of MAC-based VLANs using
SNMP. For more information, refer to the IronWare MIB Reference Guide.

Displaying Information about MAC-based VLANs

This section describes the show commands that display information related to MAC-based VLANs.

Displaying the MAC-VLAN table

Enter the following command to display the MAC-VLAN table.
PowerConnect(config)#show table-mac-vlan
----------------------------------------------------------------
Port
----------------------------------------------------------------
1/1/1
Syntax: show table-mac-vlan
The following table describes the information in this output.
This field...
Port
Vlan
Accepted Macs
Rejected Macs
Attempted Macs
Static Macs
Static Conf
Max Macs

Displaying the MAC-VLAN table for a specific MAC address

Enter the following command to display the MAC-VLAN table information for a specific MAC
address.
PowerConnect(config)#show table-mac-vlan 0000.0010.1001
-------------------------------------------------------------------------------
MAC Address
-------------------------------------------------------------------------------
0000.0010.1001
Syntax: show table-mac-vlan <mac-address>
The following table describes the information in this output.
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Vlan Accepted Rejected
Macs Macs
N/A 1 1
Displays...
The port number where MAC-based VLAN is enabled.
Not applicable for this feature, will always display n/a.
The number of MAC addresses that have been successfully authenticated (dynamic hosts)
combined with the number of active static MAC addresses (static hosts).
The number of MAC addresses for which authentication has failed for dynamic hosts.
The number of attempts made to authenticate MAC addresses.
The number of currently connected active static hosts.
The number of static hosts that are configured on the physical port.
The maximum number of allowed MAC addresses.
Port Vlan Authenticated Time
1/1/1
Configuring MAC-based VLANs using SNMP
Attempted Static
Macs Macs
0 0
2 Yes 00d00h05m45s Ena
Static Max
Conf Macs
1 10
Age dot1x
Dis
15
537