Neighbor Allowas-In - Dell S4810 Reference Manual

Version 7.8.1.0
Version 7.7.1.0

neighbor allowas-in

Set the number of times an AS number can occur in the AS path.
S4810
Syntax
neighbor {ip-address | peer-group-name} allowas-in number
To return to the default value, use the no neighbor {ip-address | peer-
group-name} allowas-in command.
Parameters
ip-address
peer-group-
name
number
Defaults Not configured.
Command ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage
You cannot set this configuration for a peer that is associated with a peer group.
Information
Similarly, you cannot associate a peer to a peer group if that peer is already
configured with these settings.
Related bgp four-octet-as-support
Commands
416
Introduced on the S-Series.
Introduced on the C-Series.
(OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
Enter the name of the peer group to set the advertisement
interval for all routers in the peer group.
Enter a number of times to allow this neighbor ID to use the
AS path. The range is from 1 to 10.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
— enables 4-byte support for the BGP process.
Border Gateway Protocol